Re: LF: the 92 turns basic into assembly

Re: LF: the 92 turns basic into assembly

• To: list-fargo@lists.ticalc.org
• Subject: Re: LF: the 92 turns basic into assembly
• From: highlander15@juno.com
• Date: Sun, 22 Jun 1997 17:24:12 PST
• References: <Pine.ULT.3.95.970622155636.2846A-100000@simba.lakeside.sea.wa.us>
• Reply-To: list-fargo@lists.ticalc.org

No, I mean from within a fargo program.  How can I use TIOS variables
from within a fargo program?

Chris
clambert@geneva.edu

On Sun, 22 Jun 1997 20:09:27 -0500 Aaron Engelhart
<engelhar@freenet.msp.mn.us> writes:
>This is covered in the manual; you should check the instruction 
>appendix
>(I think that the instruction we were discussing was NewFold).
>
>highlander15@juno.com wrote:
>> 
>> I have not been on for a while, so I don't know if this has been
>> discussed or not...
>> How can a programmer access these instructions?  How easy is it to 
>pass
>> parameters or variables to a fargo program from TI BASIC or the 
>command
>> line?  If this has been discussed, email privately.
>> 
>> Chris
>> clambert@geneva.edu
>

• Re: LF: the 92 turns basic into assembly
• From: Kyle Stemen <blue-lightning@usa.net>

• Re: LF: the 92 turns basic into assembly
• From: Scott Graham <scottg@simba.lakeside.sea.wa.us>

• Prev: Re: LF: the 92 turns basic into assembly?
• Next: Re: LF: Need to check whether just the modifier key has been pressed
• Index(es):
  • Main
  • Thread