Re: LF: the 92 turns basic into assembly
[Prev][Next][Index][Thread]
Re: LF: the 92 turns basic into assembly
highlander15@juno.com wrote:
>
> No, I mean from within a fargo program. How can I use TIOS variables
> from within a fargo program?
You have to convert them. Fargo uses binary, and TIOS uses Binary
encoded decimal with some extra junk. I once made a program for it, but
gave up after it was almost done. I had the converting part right, but
not some other parts.
>
> Chris
> clambert@geneva.edu
>
> On Sun, 22 Jun 1997 20:09:27 -0500 Aaron Engelhart
> <engelhar@freenet.msp.mn.us> writes:
> >This is covered in the manual; you should check the instruction
> >appendix
> >(I think that the instruction we were discussing was NewFold).
> >
> >highlander15@juno.com wrote:
> >>
> >> I have not been on for a while, so I don't know if this has been
> >> discussed or not...
> >> How can a programmer access these instructions? How easy is it to
> >pass
> >> parameters or variables to a fargo program from TI BASIC or the
> >command
> >> line? If this has been discussed, email privately.
> >>
> >> Chris
> >> clambert@geneva.edu
> >
References: