[TI-H] Re: TI-83 Parallel link cable
[Prev][Next][Index][Thread]
[TI-H] Re: TI-83 Parallel link cable
I'm gonna build the serial link cable, all I need now is 2 4.7v zener
diodes... Pity the shops are closed today :(
>From: "Jonathan Gordon" <jdgordon@optushome.com.au>
>Reply-To: ti-hardware@lists.ticalc.org
>To: <ti-hardware@lists.ticalc.org>
>Subject: [TI-H] Re: TI-83 Parallel link cable
>Date: Sun, 1 Sep 2002 21:50:34 +1000
>
>
>i had the same problem a while ago, i found the parallel link was very
>unreliable (even though it is the simplest and cheapest) it olny seemed to
>work proprly and reliably with the ti-82, luckly for me i got the ti-83+
>and
>a free black link cable from ti
>arnt i luky? so now dont need to worry bout the link
>----- Original Message -----
>From: "Tristan Schaap" <tristanschaap60@hotmail.com>
>To: <ti-hardware@lists.ticalc.org>
>Sent: Sunday, September 01, 2002 9:46 PM
>Subject: [TI-H] Re: TI-83 Parallel link cable
>
>
> >
> > I tested it on the test program from the ti-calc.org site, and a program
> > called CAL. I've already tried 1. Removing the resistors from the design
>2.
> > Replacing the batteries in the TI-83. (The test program from the site
>works,
> > but not all of them work. The screen capture doesn't work (Times out)
>the
> > LC85 program works fine, and the TEST program works fine too).
> >
> >
> > >From: "David Phillips" <david@acz.org>
> > >Reply-To: ti-hardware@lists.ticalc.org
> > >To: <ti-hardware@lists.ticalc.org>
> > >Subject: [TI-H] Re: TI-83 Parallel link cable
> > >Date: Sun, 1 Sep 2002 05:55:25 -0500
> > >
> > >
> > >Tristan Schaap writes:
> > > > I just built a link cable (The parallel version from the site), but
> > > > I'm having some trouble. According to several programs, the link
> > > > cable is fine. But when I try to send it gives an Error in Xmit
> > > > error. If I try to send a file from the calc to the PC it gives the
> > > > same error on the calc, and a 'Header too large' error on the PC.
>Can
> > > > anyone please help me with this? (I've also tried using different
> > > > comps, a P90, a P120 and a PIII900)
> > >
> > >Your question is lacking some crucial information. Which programs make
>you
> > >think the cable is fine? Which program gives you the error message?
> > >
> > >Be aware that you cannot use the TI software with a parallel link. You
> > >must
> > >use special link software that has support for it.
> > >
> > >--
> > >David Phillips <david@acz.org>
> > >http://david.acz.org/
> >
> >
> >
> >
> >
> >
_________________________________________________________________
Meld je aan bij de grootste e-mailservice ter wereld met MSN Hotmail:
http://www.hotmail.com/nl
Follow-Ups: