Re: TI-H: Problems with BCC serial link
[Prev][Next][Index][Thread]
Re: TI-H: Problems with BCC serial link
Wait a second, there is a homemade link cable that works under TI's software?
Bryan
----- Original Message -----
From: "Kaven Rousseau" <omnisync@videotron.ca>
To: <ti-hardware@lists.ticalc.org>
Sent: Thursday, January 13, 2000 4:02 PM
Subject: Re: TI-H: Problems with BCC serial link
>
> Black Cable Compatible link :P
> You can use it with TI's software.
>
> Kaven
>
> At 16:10 13-01-2000 -0600, you wrote:
>
> >From: Kaven Rousseau <omnisync@videotron.ca>
> > > Thanks for helping ! I knew someone out there could help me
> >
> >No problem, glad to help. What the heck is a BCC link anyway? :)
> >
> >DK
> >
> > > At 15:43 13-01-2000 -0600, you wrote:
> > >
> > > >From: Kaven Rousseau <omnisync@videotron.ca>
> > > > > I'm using 2x 2N4401 (it's written EBC on it - dunno what it means)
> > > >
> > > >the EBC indicates which pins are the Emitter, Base and Collector,
> > > >no need to refer to the documentation on that one.
> > > >
> > > > > If my transistors are wrong way... I guess I'll have to buy new ones
> >as
> > > > > everything is soldered in 1cm³ :-) It was kinda hard to fit everything
> > > >into
> > > > > the little box.
> > > >
> > > >I recommend breadboards for prototypes :) I always make sure I
> > > >have enough parts for two or three copies of anything I make, so
> > > >after I get the prototype working, I can then build another one on
> > > >the final material, and still have the prototype to refer to if it
> >doesn't
> > > >work.
> > > >
> > > >DK
> > >
> > >
> > > ,
> > > |
> > > | Kaven Rousseau
> > > | omnisync@videotron.ca
> > > | FingerPrint: F1C8 F915 9F0F DD5E DACB 024B 5C6F 163D F097 40D6
> > > `------------------- ---- -- -
> > >
> > >
>
>
> ,
> |
> | Kaven Rousseau
> | omnisync@videotron.ca
> | FingerPrint: F1C8 F915 9F0F DD5E DACB 024B 5C6F 163D F097 40D6
> `------------------- ---- -- -
>
>
>
Follow-Ups:
References: