Re: TI-H: Newbie Questions

Re: TI-H: Newbie Questions

• To: ti-hardware@lists.ticalc.org
• Subject: Re: TI-H: Newbie Questions
• From: Grant Stockly <gussie@alaska.net>
• Date: Tue, 9 Feb 1999 23:20:13 -0900
• Delivered-To: ti-hardware-outgoing@towerguard.unix.edu.sollentuna.se
• Delivered-To: ti-hardware@lists.ticalc.org
• In-Reply-To: <36C108F1.1DB1BEE0@ff.lakeheadu.ca>
• References: <19990210031758.5483.qmail@hotmail.com>
• Reply-To: ti-hardware@lists.ticalc.org

A standard vacum motor at about 14v should twist it at a slow enough speed.


>The type of wire is not all that specific, you can do like I did and find
>enough wire to make up ~12 feet, and divide it up three ways. Twist 'em
>together or tape or do nothing, it should still work either way.
>(7 pieces make up 3 4' lengths)  :)
>
>Jesus Godson wrote:
>
>> Hello all.
>>
>> I am new to this list, and to electronics in general, for that matter.
>> I have been reading about building a parallel port link, and I think I
>> understand it.  I have all the parts I need except for the 3 cord copper
>> wire (is that right?)  I was wondering where I could get this.  Is it at
>> Radio Shack?  If so, what part number?
>>
>> Also, if I find I am any good at this, I would like to make an IR link.
>> Approximately how big are these?
>>
>> Thanks.  Sorry if these are really stupid questions.
>>
>> Dave
>>
>> ______________________________________________________
>> Get Your Private, Free Email at http://www.hotmail.com

• TI-H: Newbie Questions
• From: "Jesus Godson" <jesus_christ00@hotmail.com>
• Re: TI-H: Newbie Questions
• From: Chris Cooper <cooper@fort-frances.lakeheadu.ca>

• Prev: Re: TI-H: radio link...what's stopping us?
• Next: Re: TI-H: ROM Dump
• Index(es):
  • Main
  • Thread