TI-H: Re: TI Robotics
[Prev][Next][Index][Thread]
TI-H: Re: TI Robotics
What do you mean by that, where did that 164 come from? :)
>Yeah... The 164 is an IC...
>
>
>>If you could post info on this, that would be great because I am still
>>interested! I know i will not use 897 motors, but 8 might seem
>>limiting, so I would probably use only a few of that 897. Will these
>>extra I/O lines remove the need for the flipflops, and primaraly only
>>require the PN222 resistors?
>>
>>
>>>897 LEDs would take about 17 amps. :) Are you sure?
>>>
>>>You might need to get a $12.50 pack of 100 PN222 transistors to drive
>>those
>>>897 motors. :)
>>>
>>>Grant
>>>
>>>Mel has a great example on doing this. If you want, I can post some
>>junk...
>>>
>>>
>>>>I would also like to hear your ideas on this! So basically if I had
>>>>these 897 I/O lines, I could use 897 different motors/LEDS... which
>>>>would eliminate the flip flops and other methods, right?
>>>>
>>>>
>>>>>> >How could I make one TI button start the LED and the other the
>>>>motor?
>>>>>> >Does the TI linking support simultanious I/O?
>>>>>>
>>>>>> the little port has 2 IO lines that you can set or clear at the
>>same
>>>>time.
>>>>>>
>>>>>> I could tell you how to get 8 I/O lines for $.40 if you want...
>>>>>>
>>>>>> And for $12.36 I can get about 897 I/O lines...
>>>>>and how would YOU do this(your ideas on the subject, :) )
>>>>>
>>>>
>>>>
>>>>______________________________________________________
>>>>Get Your Private, Free Email at http://www.hotmail.com
>>>
>>>
>>
>>
>>______________________________________________________
>>Get Your Private, Free Email at http://www.hotmail.com
>
>
______________________________________________________
Get Your Private, Free Email at http://www.hotmail.com
Follow-Ups: