Re: LF: Plese Read and Help
[Prev][Next][Index][Thread]
Re: LF: Plese Read and Help
I have rom version 1.11 i my calc. It runs fargo just fine.
Sorry, the problems is somewhere else.
Michael Wulff Nielsen
mal@dit.ou.dk
On Tue, 10 Dec 1996 that1guy@juno.com wrote:
> EASY EXPLINATION:
>
> ROM VERSION 1.11 will NOT run Fargo... Sorry :(
>
> that1guy@juno.com
>
>
> On Tue, 10 Dec 1996 17:33:21 -0600 junker@ncn.net (Eric Junker) writes:
> >Note: This isn't your average newbie problem. Read on.
> >
> >I just got my 92 a few days ago and I am trying to install Fargo. I
> >have
> >the official graph link and am using TI's software for Windows95. I
> >have
> >ROM version 1.11. I downloaded Fargo and made a backup of my calc and
> >then
> >ran putfargo. So far so good. I then sent the backup to my calc and
> >as
> >normal it has an error at 99%. When the error occurrs my calc's
> >screen goes
> >blank. I'm not sure if it is off or if the screen just went blank.
> >Any way
> >when I try to turn it on nothing happens. I tried increasing the
> >contrast
> >but that doesn't work either. I try to send the libs put I get a link
> >error
> >so I took out one battery and held down the on and ( key. When I do
> >this
> >the screen comes on full contrast so I lower it but my screen is
> >MISSING THE
> >TOOLBAR. The F1, F2, etc. don't work either. I am now able to
> >transfer the
> >libraries. Once the libs were transfered I pressed shift-on but that
> >didn't
> >work so I typed shell() and the calc pauses until I hit enter. I am
> >getting
> >what fargo.txt describes here
> >
> >"If the Fargo core is not present on your TI-92, pressing [Shift] [ON]
> >will
> >have no effect. When Fargo programs are launched from TI-BASIC, they
> >will
> >simply pause the calculator and wait for [ENTER] to be pressed."
> >
> >I have also tried using a pre-installed backup but I get the same
> >results.
> >
> >Why isn't the core getting onto my calc?
> >
> >Eric Junker
> >junker@ncn.net
> >
> >
>
References: