Re: LF: Plese Read and Help
[Prev][Next][Index][Thread]
Re: LF: Plese Read and Help
EASY EXPLINATION:
ROM VERSION 1.11 will NOT run Fargo... Sorry :(
that1guy@juno.com
On Tue, 10 Dec 1996 17:33:21 -0600 junker@ncn.net (Eric Junker) writes:
>Note: This isn't your average newbie problem. Read on.
>
>I just got my 92 a few days ago and I am trying to install Fargo. I
>have
>the official graph link and am using TI's software for Windows95. I
>have
>ROM version 1.11. I downloaded Fargo and made a backup of my calc and
>then
>ran putfargo. So far so good. I then sent the backup to my calc and
>as
>normal it has an error at 99%. When the error occurrs my calc's
>screen goes
>blank. I'm not sure if it is off or if the screen just went blank.
>Any way
>when I try to turn it on nothing happens. I tried increasing the
>contrast
>but that doesn't work either. I try to send the libs put I get a link
>error
>so I took out one battery and held down the on and ( key. When I do
>this
>the screen comes on full contrast so I lower it but my screen is
>MISSING THE
>TOOLBAR. The F1, F2, etc. don't work either. I am now able to
>transfer the
>libraries. Once the libs were transfered I pressed shift-on but that
>didn't
>work so I typed shell() and the calc pauses until I hit enter. I am
>getting
>what fargo.txt describes here
>
>"If the Fargo core is not present on your TI-92, pressing [Shift] [ON]
>will
>have no effect. When Fargo programs are launched from TI-BASIC, they
>will
>simply pause the calculator and wait for [ENTER] to be pressed."
>
>I have also tried using a pre-installed backup but I get the same
>results.
>
>Why isn't the core getting onto my calc?
>
>Eric Junker
>junker@ncn.net
>
>
Follow-Ups:
References: