Re: TI-H: Dead?
[Prev][Next][Index][Thread]
Re: TI-H: Dead?
Cool, thanks a lot. I'll look into it.
In a message dated 1/19/2000 10:25:34 PM Central Standard Time,
kaus@cybrzn.com writes:
> whereas the spinterface is a powered version of the link port, the module
> port on the e2 allows full use of a 6bit data bus from the calc, through
the
> e2, and into whatever device you want.
> to be used more efficiently, it owuld probably need some line restriction
> bit (e.g. a device would only send if the line was low. and he would only
> send after he asserted the line.)
> the 8pin port comes from + and - voltage and then 6 data pins.
> to use the mod port, you need to send the correct codes to the e2 unit. i
> suggest you go to dh85.ticalc.org and browse the document archive section.
> Specification 2 (v3) is most relevent to this discussion. See section
2.3,
> which discusses in further detail the methods of using what I call the MPCP
> (Module port control protocol. Original, eh?)