Well a good meter wont lie, but a 20MHz signal
and an oscilloscope is better.
Brenden McNeil Microsoft Certified
Professional A+ Certified Service Technician bmcneil@delanet.com Fax: (305)
675-0871 AOL Instant Messenger: mcneil1458 ICQ: 9155183 http://www.bmcneil.com
>
-----Original Message----- > From: owner-ti-hardware@lists.ticalc.org >
[mailto:owner-ti-hardware@lists.ticalc.org]On
Behalf Of Grant Stockly > Sent: Saturday, January 01, 2000 10:58
PM > To: ti-hardware@lists.ticalc.org >
Subject: RE: TI-H: Ethernet 10BASE2 cabling
tester > > > > I never trust meters... > > I
send a 20MHz signal through the cable and look at it from the other end >
(no terminator). > > If it comes out within standard tol. of 10b2
ethernet, I let it be. If > not, I check for shielding holes with an
interference meter. > > But...the biggest reason for doing this is
so that 10.756GHz signals don't > get all messed up. Not
ethernet. > > Grant > > > >I always use a
meter... > > > >Brenden McNeil > >Microsoft Certified
Professional > >A+ Certified Service Technician > >bmcneil@delanet.com > >Fax: (305)
675-0871 > >AOL Instant Messenger: mcneil1458 > >ICQ:
9155183 > >http://www.bmcneil.com > > >
> > >> -----Original Message----- > >> From: owner-ti-hardware@lists.ticalc.org >
>> [mailto:owner-ti-hardware@lists.ticalc.org]On
Behalf Of Per Jonsson > >> Sent: Saturday, January 01, 2000 3:50
PM > >> To: ti-hardware@lists.ticalc.org >
>> Subject: TI-H: Ethernet 10BASE2 cabling tester > >> >
>> > >> > >> > >> Does anybody have
some sort of plans to build a cabling tester for > >> 10BASE2, for
example to check you have crimped the connectors > correctly? >
>> > >> /Per > >> > >> >
>> > > >