TI-H: empeg player

To: <ti-hardware@lists.ticalc.org>
Subject: TI-H: empeg player
From: "David Knaack" <dknaack@geocities.com>
Date: Thu, 1 Apr 1999 12:53:28 -0600
Delivered-To: ti-hardware-outgoing@towerguard.unix.edu.sollentuna.se
Delivered-To: ti-hardware@lists.ticalc.org
Reply-To: ti-hardware@lists.ticalc.org


Thought some of you might get a kick out of this:

http://www.empeg.com/main.html

empegCAR Technical Specifications

Hardware

Processor  220MHz StrongARM S-1100-DA
Flash memory  1MB
RAM  8MB 60ns FPM
DSP  SAA7705H
DACs  16 bit sign-magnitude, fourfold oversampling digital filters, noise
shaping
Tuner  FM fuzzy logic autotuning radio, full RDS, RBDS capability
FM tuning range  88 to 108 MHz, 12.5 kHz steps
Display  128 x 32 dot matrix vacuum fluorescent display, 2 bits per pixel
IR capability  SIR IrDA I/O, Consumer IR input
Buttons  4 software assignable pushbuttons, in diamond layout on front panel
HDD ports  2 ATA 2.5" HDD standard 2MM headers on main board HDD bays accept
17mm, 12.7mm or 8mm standard laptop drives with corner mounting
screws.Serial IO Full 9-pin PC serial port on head unit, data rate to
230Kbits/s. TX, RX, GND, +12V @ 100mA on 300mm flying lead from docking
connector, terminated in 9 pin female socket
USB  12MBit/s standard type B socket on head unit
RF input  Standard antenna socket with adaptor for euro socket
Power input  +12V on 300mm flying lead fused at 2A with inline fuseholder.
Negative earth only
Auxillary control output  +12V @ 1A maximum on 300mm flying lead
Audio outputs  1V line level stereo RCA jacks. 4V line level front & rear
stereo
  RCA line jacks on docking connector
Audio inputs  1V line level stereo RCA line jacks

Audio

DAC sample rate  fixed 44.1KHz
DAC typical S/N ratio  110dBA

Follow-Ups:

Re: TI-H: empeg player

From: Dan <danti@applecyber.dyndns.com>