Re: TI-H: TIN?...

To: <ti-hardware@lists.ticalc.org>
Subject: Re: TI-H: TIN?...
From: "Miles Raymond" <m_rayman@bigfoot.com>
Date: Fri, 30 Oct 1998 17:31:10 -0600
Delivered-To: ti-hardware-outgoing@towerguard.unix.edu.sollentuna.se
Reply-To: ti-hardware@lists.ticalc.org


Why do all of this?  Just make a hub that connects like wires to each other, and set up the IC2
program on each caclulator.  I don't understand why the "hub" would need an amp...

-Miles Raymond

-----Original Message-----
From: ns [despuqué] <worldsnow@hotmail.com>
To: ti-hardware@lists.ticalc.org <ti-hardware@lists.ticalc.org>
Date: Friday, October 30, 1998 3:40 PM
Subject: TI-H: TIN?...


>
>I was trying to think of a way to have a network that wouldn't be too
>dificult... I think you could have a small hub that would receive data
>from one calc, and broadcast it to all of the other calcs.  With this, I
>mean the signal would be amplified for distribution to the other calcs
>using some sort of amp and voltage reg. here is something:
>
>C1  C2  C3  C4
>|   |   |    |
> \  |   |   /
>
>   AMP/volt reg/IO switch
>
>C1 would send something, and then it would go through the amp and
>broadcast to C2,C3,and C4. That would just be the hardware... the
>software could then make address determinates. It was just a thought as
>an alternative to the one with the Philips(etc.) chip.
>
>-n
>
>______________________________________________________
>Get Your Private, Free Email at http://www.hotmail.com