TI-H: Re: TI Robotics
[Prev][Next][Index][Thread]
TI-H: Re: TI Robotics
If you could post info on this, that would be great because I am still
interested! I know i will not use 897 motors, but 8 might seem
limiting, so I would probably use only a few of that 897. Will these
extra I/O lines remove the need for the flipflops, and primaraly only
require the PN222 resistors?
>897 LEDs would take about 17 amps. :) Are you sure?
>
>You might need to get a $12.50 pack of 100 PN222 transistors to drive
those
>897 motors. :)
>
>Grant
>
>Mel has a great example on doing this. If you want, I can post some
junk...
>
>
>>I would also like to hear your ideas on this! So basically if I had
>>these 897 I/O lines, I could use 897 different motors/LEDS... which
>>would eliminate the flip flops and other methods, right?
>>
>>
>>>> >How could I make one TI button start the LED and the other the
>>motor?
>>>> >Does the TI linking support simultanious I/O?
>>>>
>>>> the little port has 2 IO lines that you can set or clear at the
same
>>time.
>>>>
>>>> I could tell you how to get 8 I/O lines for $.40 if you want...
>>>>
>>>> And for $12.36 I can get about 897 I/O lines...
>>>and how would YOU do this(your ideas on the subject, :) )
>>>
>>
>>
>>______________________________________________________
>>Get Your Private, Free Email at http://www.hotmail.com
>
>
______________________________________________________
Get Your Private, Free Email at http://www.hotmail.com
Follow-Ups: