Re: TI-H: New EII!!! Subcontracting to build them
[Prev][Next][Index][Thread]
Re: TI-H: New EII!!! Subcontracting to build them
Sounds good!
The 9 pin connector might be a good idea, since the MMOD would probably be
made from it's case!
The problem is the case will need modification.
The screw posts will most likely need to be cut out and then the case just
glued shut. I'll have to see if it'll fit into the case with the chip and
connector. I think it could!
That'll also eliminate confusion about Which plug is which!
Also, good news! I moved to my Mom's and it's only 2 blocks from where I work
and I also have a BIG table for a desk, and it holds both my mac and PC. I
found a program that does schematics and auto routing and it's like $30 to
unlock the auto routing.
I'll send it to you if you need it.
I've come up with some GREAT ideas to GREATLY reduce the time to construct my
new robot (on my page) and I'll have a little more time cause of that. I don't
need to worry about cash cause this TV producer is paying $200, which covers
the motors and probably half the hardware! Electronics are no problem, since
I'm great with Neural networks!
Put simply, I'll have a little more time to blow (though it's still not much).
I'll be happy to design a PCB for you if you send me a finalized schematic. I
told you how small i made the EuP board a while ago!
I'll see if Rat shack has a suitable case. I LOVE your idea of using the 9-pin
connector for the MMODs. I don't think any EuP MMODs ever got built. I hope
it's diferent this time! (:
--
Richard Piotter
richfile@prairie.lakes.com
The Richfiles TI Hardware and BASIC web page:
http://www.geocities.com/SiliconValley/Lakes/5081/Richfiles.html
Follow-Ups:
References: