Re: TI-H: EII idea

To: ti-hardware@lists.ticalc.org
Subject: Re: TI-H: EII idea
From: "Joseph M. Geiss" <joseph@mail.bcpl.lib.md.us>
Date: Thu, 30 Jul 1998 15:15:15 -0400
Delivered-To: ti-hardware-outgoing@towerguard.unix.edu.sollentuna.se
References: <fc.000f62d10010440d000f62d10010440d.104412@pinecrest.edu> <35C0A0C5.1A2BB407@flash.net>
Reply-To: ti-hardware@lists.ticalc.org


I just use 2 watch repair screw drivers to get PLCC IC's out, works fine for
me

Bryan Rittmeyer wrote:

> I believe Rich was working on something called MMOD's, which would
> be memory chips in a DB9 connector. However, since the memory
> chips are in a PLCC socket, you only need a PLCC extractor to pop
> the chip, and then just push in a new one. The packaging of the
> memory substrate, and the PLCC socket itself, can be viewed
> as a kind of 'disk'.
>
> Bryan
>
> David Norelid wrote:
> >
> > maybe this has already been brought up but i had an idea for eii 'disks'
> > that would plug into the eii controller unit. instead of building a new
> > controller for each chip you want to use, just put the chip in a
> > cartdridge and plug a new one in for each 512k you want to use.
> >
> > FUZZ
> > I Don't See Why Not
> > -------------------
> > listen.to/yankovic
>
> --
> Bryan Rittmeyer
> mailto:bryanr@flash.net
> http://www.flash.net/~bryanr/

References:

TI-H: EII idea

From: fuzz@pinecrest.edu (David Norelid)

Re: TI-H: EII idea

From: Bryan Rittmeyer <bryanr@flash.net>