Re: TI-H: CryoCalc :)

To: ti-hardware@lists.ticalc.org
Subject: Re: TI-H: CryoCalc :)
From: William Keung aka ShYGuY <wqk6162@is4.nyu.edu>
Date: Fri, 23 Jan 1998 10:09:38 -0500 (EST)
In-Reply-To: <19980123004722.20778.qmail@hotmail.com>
Reply-To: ti-hardware@lists.ticalc.org


I think you also need a suitable fan to dissipate the heat off the Peltier
junctions on the free end.

On Thu, 22 Jan 1998, Richard Piotter wrote:

> 
> I HAVE THE SOLUTION!!! Peltier junctions! They run on as little as 3v DC 
> and at higher voltaves will produce a difference of 68 degrees C. Two 
> stacked would create an even greater temp difference and can be run on 
> 6v each, in paralel. You'll need a lot of power, and you HAVE to install 
> a heat sink to keep it from burning up. You'd need to cut a hole in the 
> case to expose the heatsink and you'll need something to protect the 
> cable that connects the screen.
> 
> You can get them from All Electronics.
> 
> >
> >
> >sounds like an interesting idea... perhaps a small heat pump on the 
> z80?
> >
> >-joshua pollack
> >
> >
> 
> 
> ______________________________________________________
> Get Your Private, Free Email at http://www.hotmail.com
>

References:

Re: TI-H: CryoCalc :)

From: "Richard Piotter" <richfiles1@hotmail.com>