RE: TI-H: Parallel Link Not Working???

To: "'ti-hardware@lists.ticalc.org'" <ti-hardware@lists.ticalc.org>
Subject: RE: TI-H: Parallel Link Not Working???
From: Christopher Kalos <raptorone@geocities.com>
Date: Wed, 24 Sep 1997 18:18:08 -0400
Reply-To: ti-hardware@lists.ticalc.org

I had no problems, but I also ran cal's built in test routine.  maybe that's enough.  Just make sure to use the silicon switching diodes specified about a million times on this list.  1Nsomething, I can never remember, but I have a load of them... :)
Christopher Kalos
raptorone@geocities.com
raptor_one@hotmail.com
Executive Director/Administrator
Virtual Technologies Developer's Group


----------
From: 	Chris Cooper[SMTP:cooper@fort-frances.LakeheadU.Ca]
Sent: 	Tuesday, September 23, 1997 6:12 PM
To: 	ti-hardware@lists.ticalc.org
Subject: 	TI-H: Parallel Link Not Working???

I've tried to get the Parallel Link Working, but  I can never get the
correct values with  LINKTEST.   I've switched wires and diodes around,
but I can only ever get two of the four vaules to match up.  Any one
have any ideas?

Warning: Could not process part with given Content-Type: application/ms-tnef