Re: TI-H: Add LEDs to your link cable!
[Prev][Next][Index][Thread]
Re: TI-H: Add LEDs to your link cable!
eplese@Lnd.com wrote:
>
> I have heard a lot of people saying my design won't work, but it
> DOES. I haven't yet tried it on the TI-TI link cable, but I have
> successfully built this for the parallel link. With the 10,000 ohm
> resistors, the LEDs draw an extremely small amount of electricity
> (about .0003 amps) which is far too small to affect any link
> transmissions.
I should think that while the LED's aren't taking all that much current,
the 10K resistors are...aren't they? I have minimal electronics
training, but enough to know that resistors cut down on the voltage (and
thus the amps as well, since they're proportional).
--
Jake Robb Email:jake@netrus.net
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
< "Diplomacy is the art of saying 'nice >
< doggy' until you can find a rock." >
< -Unknown >
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
References: