Re: TI-H: Basic $5 link question
[Prev][Next][Index][Thread]
Re: TI-H: Basic $5 link question
Are you using the 83 software, sorry had to ask.... next.... If you have
"tweaked" insides of your ti you might have screwed with your port by
mistake... if so just open it up and re-solder it (it may not be the
best way but it seems to work everytime)... also make sure that your its
pluged all of the way in the port socket... and i've noticed that you
cant get it to work if you are useing an extention cord from the printer
port... i.e. zip drive cable... hehe... then make sure you push it all
of the way in the port.... you really have to pay attention to this if
you used another 2.5mm plug instead of the ti link one... make sure the
white red and grounds are all right... and if that dont work... i have
no clue... sorry
MAndersen@dhvx20.csudh.edu
xenocide@erols.com wrote:
>
> I just finished building the $5 parallel link cable, it
> seems to be a fairly good job (for someone with little soldering and no.........
Follow-Ups:
References: