Re: TI-H: Multimaster I2C routines

Re: TI-H: Multimaster I2C routines

• To: ti-hardware@lists.ticalc.org
• Subject: Re: TI-H: Multimaster I2C routines
• From: Osma Suominen <ozone@clinet.fi>
• Date: Sat, 31 May 1997 21:20:26 +0000
• References: <338DDF4A.23CF6B44@clinet.fi> <338E1A79.CA332424@dhvx20.csudh.edu> <338EB7DC.5C1C27CB@clinet.fi> <338F84AF.D6920C58@dhvx20.csudh.edu> <338FEE04.7F2A2E4F@clinet.fi> <3391B9AD.5B46@sisna.com>
• Reply-To: ti-hardware@lists.ticalc.org

Andy Johnson wrote:

> Actually, you don't need asm for all of the calcs.  You could use a
> 83/85 as a hub that would communicate in the other calc's built in
> software.

Not so, AFAIK, because the built in software in the calculators have no
sorts of identification, so you can't tell to which calc a packet is
destined. Unless you make a very complicated linkup system, that is. But
with just straight wire this is impossible.

-Ozone

-- 
*** Osma Suominen *** ozone@clinet.fi *** http://www.clinet.fi/~ozone
***

• TI-H: Multimaster I2C routines
• From: Osma Suominen <ozone@clinet.fi>
• Re: TI-H: Multimaster I2C routines
• From: Onceler <MAndersen@DHVX20.CSUDH.EDU>
• Re: TI-H: Multimaster I2C routines
• From: Osma Suominen <ozone@clinet.fi>
• Re: TI-H: Multimaster I2C routines
• From: Onceler <MAndersen@DHVX20.CSUDH.EDU>
• Re: TI-H: Multimaster I2C routines
• From: Osma Suominen <ozone@clinet.fi>
• Re: TI-H: Multimaster I2C routines
• From: Andy Johnson <prjohnson@sisna.com>

• Prev: Re: TI-H: Multimaster I2C routines
• Next: Re: TI-H: Linking Speed - was Re: Modem
• Index(es):
  • Main
  • Thread