Re: Building a Graph link that works

To: CALC-TI@LISTS.PPP.TI.COM
Subject: Re: Building a Graph link that works
From: Joseph Gaffney <gaffney@THETHINKER.COM>
Date: Tue, 3 Mar 1998 20:53:26 -0500
Comments: To: Dan Cogswell <dougcogswell@EMAIL.MSN.COM>
In-Reply-To: <OJo7oyjR9GA.241@upnetnews03>
Reply-To: Joseph Gaffney <gaffney@THETHINKER.COM>

At 06:39 PM 3/2/98 -0600, Dan Cogswell wrote:
>Here is a diagram that shows how to build a graph link.  I built one, and so
>did my friend, and they work great.  It will cost you 5$ at most.  For the
>parallel port connector, I found an old printer cable and spliced it - I
>used a volt meter to figure out which wires are connected to which pins.
>
>If you decide to build it, the best transferring software is Link85.
>Although it runs through DOS, it's much faster than any other I've found.
>You can download it at www.ticalc.org.

ENOUGH OF THESE DAMN SENDS!@&$!@  IVE GOTTEN 5 ALLREADY!!!!!!!!!!



- Joseph Gaffney
- gaffney@thethinker.com
- http://www.thethinker.com/members/gaffney/
- http://www.ArchAgency.com/

References:

Building a Graph link that works

From: Dan Cogswell <dougcogswell@EMAIL.MSN.COM>

Prev: Finger Power
Next: Re: from Mexico
Index(es):
- Main
- Thread