Re: Building a Graph link that works


[Prev][Next][Index][Thread]

Re: Building a Graph link that works



Dan Cogswell wrote:

> Here is a diagram that shows how to build a graph link.  I built one, and so
> did my friend, and they work great.  It will cost you 5$ at most.  For the
> parallel port connector, I found an old printer cable and spliced it - I
> used a volt meter to figure out which wires are connected to which pins.
>
> If you decide to build it, the best transferring software is Link85.
> Although it runs through DOS, it's much faster than any other I've found.
> You can download it at www.ticalc.org.
>
>  [Image]

That schematic is the same for the parallel link cable which can be found at
http://www.ticalc.org/mirror/parallel/

--
Bryan Rabeler <brabeler@ticalc.org>
   File Archives
   the ticalc.org project - http://www.ticalc.org/


References: