Re: rom upgrade
[Prev][Next][Index][Thread]
However, the TI-92's ROM is the 'test access panel - do not remove -
required for operation'... so if you have a replacement 'test access panel'
theoretically it would work...
At 22:29 11/14/96 -0700, Zenon Lynx wrote:
>Yes, sometimes. These chips are all surface mount and programmed by TI.
>It would be quite hard and expensive to get a ROM replacement, not to
>mention the effort needed to resolder that piece of surface mount
>component.
>
>"This is the most logical route, Captain"
>-= Zenon@bbs.nexes.com =-
>
>----------
>: From: Joe_Shmuckatelly@NOWHERESVILLE.ORG
>: To: Zenon
>: Subject: Re: rom upgrade
>: Date: November 14, 1996 8:27 PM
>:
>:
>: On Wed, 13 Nov 1996 22:48:32 GMT, jim@kd3bj.ampr.org (Jim Paris)
>: wrote:
>: >terryr@magg.net writes:
>: >
>: >>is there a way to upgrade rom ver.1.4?
>: >
>: >ROM = Read Only Memory.
>: >
>: >It's a bit hard to write an upgrade to it.
>: >
>: >-jim
>: >
>: >
>: Well Jim I guess you have never upgraded you video ROM BIOS
>: or your MOTHERBOARD ROM BIOS, or your modems ROM BIOS.
>: ROM chips are sometimes socketed to provide for upgrades, so the
>: question as to if the ti-92's ROM can be upgraded is a logical
>: question.
>: Smuck
>
>
+--------------------------------------------------------+
| Peter Kolbus +1.810.474.0872 |
| ae607@detroit.freenet.org #include <disclaimer.h> |
+--------------------------------------------------------+
| Due to financial difficulties, the light at the end of |
| the tunnel has been permanently disconnected. |
| |
| The packet goes out the card, into the copper, out |
| the router, onto the fiber, across the world, thru |
| the copper............ NOTHING BUT NET. |
| |
| ***Written using 100% recycled electrons*** |
| *** (80% post-consumer) *** |
+--------------------------------------------------------+
References: