A89: Custom Units in the Modes Dialog
[Prev][Next][Index][Thread]
A89: Custom Units in the Modes Dialog
Hi everyone!
I was just wondering where one could find what units are set as the default
(chosen by the user) if the unit system that is selected is CUSTOM. I'm
hoping that there is some sort of structure on the calc that is sorta like
the ModeSettings pointer in TIGCC.
Thanks!
Greg
_________________________________
All parts should go together without forcing. You must remember that the
parts you are reassembling were disassembled by you. Therefore, if you can't
get them together again, there must be a reason. By all means, do not use a
hammer.
-- IBM maintenance manual, 1925
_________________________________________________________
Do You Yahoo!?
Get your free @yahoo.com address at http://mail.yahoo.com
References: