A86: Basic question (same one)
[Prev][Next][Index][Thread]
A86: Basic question (same one)
OK, I thought I had the dimensions correct, but tell that to my calculator.
Well, maybe it's my own fault, thanks for your help I think I know what I
need to do. I was trying to set my dimensions to 8x16, and that's just not
going to work will it? I'll have to use decimals I'm assuming to get it
accurate, because the routing I'm using is supposed to end up covering the
entire screen in black squares and have no white on it at all, but I keep
ending up w/ white lines. about 5 across from left to right, and 2-3 from
top to bottom.
-----Original Message-----
From: TGaArdvark@aol.com <TGaArdvark@aol.com>
To: assembly-86@lists.ticalc.org <assembly-86@lists.ticalc.org>
Date: Sunday, June 14, 1998 1:08 AM
Subject: Re: A86: Re: Learn ASM? Check these out!
>
>> What are my graph screen dimensions, and how would I pull this off?
>
>The dimensions are 127x63 in basic (one less than assembly). Your
>last (or first) picture would get slightly cut off.
>