[A83] Re: Getkey loop

To: assembly-83@lists.ticalc.org
Subject: [A83] Re: Getkey loop
From: Charlie Adams <charlieadams@bellsouth.net>
Date: Thu, 06 Jun 2002 13:35:43 -0500
In-Reply-To: <5.1.0.14.0.20020606132605.009eb730@mail.bellsouth.net>
References: <006f01c20d21$e4999ef0$0201a8c0@brinstar> <F247reBBsQwY6YHkidc0000b20f@hotmail.com>
Reply-To: assembly-83@lists.ticalc.org


...Then select "Z180" from the Master list box. The "Project Target" should 
automatically read "Z80180", but if it doesn't, change it accordingly....

>Hmmm.... in AppGuru when he explains how to set up a project in ZDS (Zilog
>Developer Studio) it says z80180.
>
>
> >Wrong, they use z80 (although I think it is produced by Sharp).  Please do
> >some research you post.  Do not confuse people with wrong incorrect
> >information.  That is not helpful.
> >
> > > I think so, but does replacing nc with nz help?
> > >
> > > >TI calculators use the Z80180, right?

References:

[A83] Re: Getkey loop

From: "David Phillips" <david@acz.org>

[A83] Re: Getkey loop

From: "Jimmy Pardey" <j_pardey@hotmail.com>

[A83] Re: Getkey loop

From: Charlie Adams <charlieadams@bellsouth.net>