[A83] Re: Can't Connect
[Prev][Next][Index][Thread]
[A83] Re: Can't Connect
I use graph link (grey cable) for hours sometimes, loading my program
into it every 2 to 5 minutes....Haven't had a problem. I have seen,
however, many broken link ports at my school. Perhaps the constant
plugging and unplugging of the cable loosens the port on the circuit
board. Also, it helps if you have a link with a straight end instead of
the one with the right angle. If you pull out the angled cord, it tends
to put more stress on the port. Just an idea....you guys might be having
a different problem though. Later!
Thomas Lutz
Stevens Institute of Technology
-----Original Message-----
From: assembly-83-bounce@lists.ticalc.org
[mailto:assembly-83-bounce@lists.ticalc.org] On Behalf Of techie
Sent: Saturday, December 22, 2001 9:48 PM
To: assembly-83@lists.ticalc.org
Subject: [A83] Re: Can't Connect
I've had this problem too, but most times i just reset
the calc, and it worked again(83+, SE). but it usually
went when i was transfering to alot of calcs so i
think it might be the connectors expanding due to heat
and creating a gap.
ryan
--- MuntaKHib@cs.com wrote:
> Just recently, my TI-83 Plus stopped connecting to
> my computer/other
> calculators. There's nothing wrong with the cable,
> because it worked between
> two other calculators. Is something broken, is there
> any way to fix this, and
> has anyone had this problem before?
>
>
>
______________________________________________________
Send your holiday cheer with http://greetings.yahoo.ca
References: