Re: A83: ti-83 take me off the list
[Prev][Next][Index][Thread]
Re: A83: ti-83 take me off the list
On 06-May-99, you wrote:
> i want everyone to take me off of this gay list
> u all have no lives talking about TI Calculators
> and i dont want to hear about all of your crappy questions
Please follow official instructions below to unsubscribe properly!
*******************************************************************
First, ask your Internet Provider to mail you an Unsubscribing
Kit. Then follow these directions.
The kit will most likely be the standard no-fault type. Depending
on requirements, System A and/or System B can be used. When
operating System A, depress lever and a plastic dalkron
unsubscriber will be dispensed through the slot immediately
underneath. When you have fastened the adhesive lip, attach
connection marked by the large `X' outlet hose. Twist the silver-
coloured ring one inch below the connection point until you feel
it lock.
The kit is now ready for use. The Cin-Eliminator is activated by
the small switch on the lip. When securing, twist the ring back
to its initial condition, so that the two orange lines meet.
Disconnect. Place the dalkron unsubscriber in the vacuum
receptacle to the rear. Activate by pressing the blue button.
The controls for System B are located on the opposite side. The
red release switch places the Cin-Eliminator into position; it can
be adjusted manually up or down by pressing the blue manual
release button. The opening is self- adjusting. To secure after
use, press the green button, which simultaneously activates the
evaporator and returns the Cin-Eliminator to its storage position.
You may log off if the green exit light is on over the evaporator
. If the red light is illuminated, one of the Cin-Eliminator
requirements has not been properly implemented. Press the ``List
Guy'' call button on the right of the evaporator . He will secure
all facilities from his control panel.
To use the Auto-Unsub, first undress and place all your clothes in
the clothes rack. Put on the velcro slippers located in the
cabinet immediately below. Enter the shower, taking the entire
kit with you. On the control panel to your upper right upon
entering you will see a ``Shower seal'' button. Press to
activate. A green light will then be illuminated immediately
below. On the intensity knob, select the desired setting. Now
depress the Auto-Unsub activation lever. Bathe normally.
The Auto-Unsub will automatically go off after three minutes
unless you activate the ``Manual off'' override switch by flipping
it up. When you are ready to leave, press the blue ``Shower
seal'' release button. The door will open and you may leave.
Please remove the velcro slippers and place them in their
container. If you prefer the ultrasonic log-off mode, press the
indicated blue button. When the twin panels open, pull forward by
rings A & B. The knob to the left, just below the blue light, has
three settings, low, medium or high. For normal use, the medium
setting is suggested.
After these settings have been made, you can activate the device
by switching to the ``ON'' position the clearly marked red switch.
If during the unsubscribing operation, you wish to change the
settings, place the ``manual off'' override switch in the ``OFF''
position. You may now make the change and repeat the cycle. When
the green exit light goes on, you may log off and have lunch.
Please close the door behind you.
Linus
--
wwww
(o)(O)
.--> .-------mm--(__)--mm--------.
| Linus Akesson | http://linusworld.cjb.net |
`---------------^-- ----- --- -- -- - - - `---------ooO--Ooo----------'
My mind not only wanders, sometimes it leaves completely.
References: