Sv: A83: NewBie Question

To: "ti83" <assembly-83@lists.ticalc.org>
Subject: Sv: A83: NewBie Question
From: "Thomas Turn Jensen" <Mukke@get2net.dk>
Date: Sat, 5 Sep 1998 19:48:49 +0200
Delivered-To: assembly-83-outgoing@towerguard.unix.edu.sollentuna.se
Reply-To: assembly-83@lists.ticalc.org


yeah great - but they only say it's possible... And they give me a lot of addresses of stuff - but not exactly the stuff I need as a newbie. Only thing I know abnout Maschine code / assembling is from years back when I worked a bit with it on the good old C64. But even then I wouldn't say I was very much into it :)

-----Oprindelig meddelelse-----
Fra: Linus Akesson <lairfight@softhome.net>
Til: Thomas Turn Jensen <assembly-83@lists.ticalc.org>
Dato: 5. september 1998 19:44
Emne: Re: A83: NewBie Question


>
>Try www.ti.com for a start...
>
>Linus
>
>On 05-Sep-98, Thomas Turn Jensen wrote:
>>Sorry for asking this, but could someone either give me directions to some
>>info on how to use z80 maschine code on ti-83?
>>If you could tell me where I could find a FAQ for this listserv I'd very much
>>appreciate it too.
>>Also, Where can I find an assembler? I've searched a little for "TASM" as you
>>seem to talk a lot about that but I haven't had any luck so far.
>>Thanks.
>
>>***
>>Thomas Turn Jensen
>>Icq uin => 8128636
>>IRC, Undernet => Mukke
>>***
>>If your computer gives you trouble
>>Call for Mukke on the double
>>***
>
>
>

Follow-Ups:

Re: Sv: A83: NewBie Question

From: Linus Akesson <lairfight@softhome.net>