Re: A82: Galaxian v2.0
[Prev][Next][Index][Thread]
Re: A82: Galaxian v2.0
In a message dated 98-01-30 16:35:34 EST, you write:
> Sorry about not answering the 3 question in my other response. I
> had to go to school. Heres whats up with number three. When you push
> pause for the first time in either Galaxian or Orzunoid, the contrast
> drops about three settings. The program basically is restarting the
> contrast settings. Then you push + until you reach the setting of your
> choice. The next time you press pause the contrast you selected last time
> you pressed MODE will still be enabled. I know its a pain in the butt,
> and I'll try to fix that in version 3.0(if I ever get a graphlink again).
> As for the problem with the contrast being very high when you exit and
> shut off the calc. Its the same problem occuring with ASH as the progs do
> with CrASH. This only occurs if your batteries are low so that you select
> a contrast higher than the normal settings. CrASH and ASH deal with
> having a setting higher than normal differently. CrASH and ASH(now
> I know) cause the screen to be absolutely blank until you hold 2nd+DOWN.
> Sometimes in ASH and CrASH if you select a certain setting, it will go to
> setting 9 when the calc restarts. Again I'll try to fix that in the next
> version.
> Evil Sam
actually, it doesn't only happen in low batts. The reason it messes up when
you turn it off (or APD) is that the system values are messed up. Instead of
having the contrast stored in the program, use the system values (ask Ash or
CrASH people)
~Adamman